User manual MAKITA HM1200K

[. . . ] â· Note: Specifications may differ from country to country. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can be operated on single-phase AC/DC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to enclosed safety instructions. [. . . ] (If it is difficult to move the tool retainer with your thumbs, tap it with a hammer. ) Insert the bit into the tool barrel as far as it will go. Return the tool retainer to its original position to secure the bit. 2) Pull out and turn the tool retainer 180 degrees (1/2 turn). Then insert the bit into the tool holder with the notched portion on the bit facing back toward the tool retainer. Then pull out and turn back the tool retainer 180 degrees to secure the bit. Try to pull the bit out of the tool holder to make sure the retained bit before use. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Whenever carbon brushes must be replaced, they cut out the tool automatically. When this occurs, replace both carbon brushes at the same time. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. Lubricate the tool every time the carbon brushes are replaced. Run the tool for several minutes to warm it up. Remove the crank cap using a Makita lock nut wrench 35 (optional accessory). rest the tool on the table with the bit end pointing upwards. This will allow the old grease to collect inside the crank housing. Wipe out the old grease inside and replace with a fresh grease (30 g). use only Makita genuine grease (optional accessory). [. . . ] Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. â· Do not tape, tie or otherwise secure the trigger in the "ON" position. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not increase the efficiency. [. . . ]