User manual MAKITA HM1213C

[. . . ] Model Blows per minute Overall length Net weight · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. [. . . ] Exposure to noise can cause hearing loss. Use auxiliary handle(s), if supplied with the tool. Hold power tool by insulated gripping surfaces, when performing an operation where 3 4. The cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun glasses are NOT safety glasses. it is also highly recommended that you wear a dust mask and thickly padded gloves. Be sure the bit is secured in place before operation. In cold weather or when the tool has not been used for a long time, let the tool warm up for a while by operating it under no load. Be sure no one is below when using the tool in high locations. Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. do not operate the tool at no-load unnecessarily. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Switch can be locked in "ON" position for ease of operator comfort during extended use. apply caution when locking tool in "ON" position and maintain firm grasp on tool. To start the tool, push the switch lever "ON (I)" on the left side of the tool. [. . . ] Note that the top screws are different from other screws. The bit can be secured at 12 different angles. To change the bit angle, slide the change ring forward, then turn the change ring to change the bit angle. CAUTION: Be careful not to damage the connector or lead wires especially when installing the handle. [. . . ]