User manual MAKITA HR2060

[. . . ] Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun glasses are NOT safety glasses. it is also highly recommended that you wear a dust mask and thickly padded gloves. Be sure the bit is secured in place before operation. [. . . ] Do not look in the light or see the source of light directly. nOTE: · Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Install the side grip so that the teeth on the grip fit in between the protrusions on the tool barrel. Then tighten the grip by turning clockwise at the desired position. It may be swung 360° so as to be secured at any position. Coat the bit shank head beforehand with a small amount of bit grease (about 0. This chuck lubrication assures smooth action and longer service life. Always check the direction of rotation before operation. ⷠUse the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. Clean the bit shank and apply bit grease before installing the bit. Turn the bit and push it in until it engages. 7) After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. Select one of the two modes suitable for your work needs by using this knob. For rotation only, turn the knob so that the arrow on the knob points toward the symbol on the tool body. For rotation with hammering, turn the knob so that the arrow on the knob points toward the symbol on the tool body. cAUTION: · Always set the knob fully to your desired mode symbol. If you operate the tool with the knob positioned halfway between the mode symbols, the tool may be damaged. ⷠUse the knob after the tool comes to a complete stop. [. . . ] However, the tool may back out abruptly if you do not hold it firmly. ⷠAlways secure small workpieces in a vise or similar hold-down device. We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Rotary Hammer Model No. / Type: HR2460, HR2460F are of series production and Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with 2006/42/EC from 29th December 2009 And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorized representative in Europe who is: Makita International Europe Ltd. [. . . ]