User manual MAKITA HR2400

[. . . ] â· Note: Specifications may differ from country to country. Power supply The machine should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. [. . . ] 3) After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. Wear a hard hat (safety helmet), safety glasses and/or face shield. It is also highly recommended that you wear a dust mask, ear protectors and thickly padded gloves. Be sure the bit is secured in place before operation. The screws can come loose easily, causing a breakdown or accident. In cold weather or when the machine has not been used for a long time, let the machine warm up for several minutes by operating it under no load. Be sure no one is below when using the machine in high locations. NOTE: The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. The side grip swings around to either side, allowing easy handling of the machine in any position. Important: Before plugging in the machine, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. To stop from this lock position, press the trigger and release it. 5) The speed varies from 0 to maximum, depending on the pressure applied to the trigger. The more the trigger is pressed, the faster the machine runs. 5) Important: Only reverse the direction of rotation when the motor stops completely. Turn the knob to hammer drilling symbol Install the cold chisel or bull point and then the chisel adapter (optional accessory) on the machine. [. . . ] CAUTION: As soon as the torque limiter actuates, switch off the machine immediately. This will help prevent premature wear of the machine. hole saws , core bit , diamond core bit , etc. [. . . ]