User manual MAKITA HR2413

[. . . ] The bit could fly out and injure someone seriously. When drilling or chipping into walls, floors or wherever "live" electrical wires may be encountered, DO NOT TOUCH ANY METAL PARTS OF THE TOOL!Hold the tool by the insulated grasping surfaces to prevent electric shock if you drill or chip into a "live" wire. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. [. . . ] Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed. CAUTION: There is tremendous and sudden twisting force exerted on the tool/bit at the time of hole breakthrough, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the trigger. Tool speed is increased by increasing pressure on the trigger. Always check the direction of rotation before operation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. Do not pull the switch trigger when the reversing switch lever is in the neutral position. If you pull the trigger forcibly, the switch may be damaged. Coat the bit shank head beforehand with a small amount of bit grease (about 0. This chuck lubrication assures smooth action and longer service life. Use the blow-out bulb to clean out the hole. Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling operations. The size of bits which the dust cup can be attached to is as follows. Bit diameter (mm) Dust cup 5 Dust cup 9 6 ­ 14. Select one of the two modes suitable for your work needs by using this knob. For rotation only, turn the knob so that the arrow on the knob points toward the M symbol on the tool body. For rotation with hammering, turn the knob so that the arrow on the knob points toward the r symbol on the tool body. [. . . ] CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. För spaken till läget p ör medurs rotation, och till läget q för moturs rotation. I metall kan du borra upp till 13 mm i diameter, och i trä upp till 32 mm i diameter. [. . . ]