User manual MAKITA HR2470FT

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Concrete Capacities Core bit Steel Wood No load speed (RPM) Blows per minute Overall length Net weight · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] check tightness of screws carefully before operation. In cold weather or when the tool has not been used for a long time, let the tool warm up for a while by operating it under no load. Be sure no one is below when using the tool in high locations. Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to rotary hammer safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Volts amperes hertz alternating current no load speed Class II Construction revolutions or reciprocation per minute number of blow CAUTION: Do not look in the light or see the source of light directly. Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. [. . . ] Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. NOTE: Eccentricity in the bit rotation may occur while operating the tool with no load. the tool automatically centers itself during operation. This does not affect the drilling precision. [. . . ]