User manual MAKITA HR262TD

[. . . ] Rotation with hammering Rotation only Hammering only Grip base Teeth Loosen Tighten Side grip Protrusion Bit shank Bit grease Bit Chuck cover 27. 8 kg BHR262T/HR262TD • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. 36 V Steel Wood BHR262/HR262D 26 mm 13 mm 32 mm 0 - 1 , 200 0 - 4 , 800 387 mm 4. [. . . ] Removing the quick change chuck for SDS-plus (Fig. 6) CAUTION: • Before removing the quick change chuck for SDS-plus, always remove the bit. Grasp the change cover of the quick change chuck for SDS-plus and turn in the direction of the arrow until the change cover line moves from the symbol to the symbol. Pull forcefully in the direction of the arrow. attaching the quick change drill chuck (Fig. 7) Check the line of the quick change drill chuck shows the symbol. attaching the quick change drill chuck (Fig. Place the quick change drill chuck on the spindle of the tool. Grasp the change cover of the quick change drill chuck and turn the change cover line to the symbol until a click can clearly be heard. € When only the lowermost indicator lamp (next to the “E”) blinks, or when none of the indicator lamps light, the battery capacity has run out, so the tool does not operate. In these cases, charge the battery or replace the empty battery with a fully charged one. € When two or more indicator lamps do not light even after charging is complete, the battery has reached the end of its service life. € When the upper two and lower two indicator lamps light alternately, the battery may have malfunctioned. contact your local Makita authorized service center. NOTE: • The indicated capacity may be lower than the actual level during use or immediately after using the tool. € Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. 3) CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Selecting the action mode Rotation with hammering (Fig. 8) For drilling in concrete , masonry , etc. , depress the lock button and rotate the action mode changing knob to the symbol. [. . . ] To remove the bit, pull the chuck cover down all the way and pull the bit out. 15) The bit can be secured at the desired angle. To change the bit angle, depress the lock button and rotate the action mode changing knob to the O symbol. Depress the lock button and rotate the action mode changing knob to the symbol. [. . . ]