User manual MAKITA HR2810T

[. . . ] They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. For European countries only Noise The typical A-weighted noise level determined according to 60745-2-6: Sound pressure level (LpA) : 89 dB(A) Sound power level (LWA) : 100 dB(A) Uncertainty (K) : 3 dB(A) Wear ear protection Model; HR2800, HR2810, HR2810T, HR2811F, HR2811FT We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents; EN60745, EN55014, EN61000 in accordance with Council Directives, 2004/108/EC, 98/37/EC. Vibration The vibration total value (tri-axial vector sum) determined according to EN60745-2-6: Work mode : hammer drilling into concrete, 10 mm diameter and 100 mm depth Vibration emission (ah, HD) : 20 m/s2 Uncertainty (K) : 1. For European countries only Noise The typical A-weighted noise level determined according to 60745-2-6: Sound pressure level (LpA) : 89 dB(A) Sound power level (LWA) : 100 dB(A) Uncertainty (K) : 3 dB(A) Wear ear protection DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to rotary hammer safety rules. [. . . ] to start the tool , simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Select one of the two modes suitable for your work needs by using this knob. For rotation only, turn the knob so that the arrow on the knob points toward the symbol on the tool body. For rotation with hammering, turn the knob so that the arrow on the knob points toward the symbol on the tool body. cAUTION: Always set the knob fully to your desired mode symbol. If you operate the tool with the knob positioned halfway between the mode symbols, the 2 CAUTION: Do not look in the light or see the source of light directly. Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Use the knob after the tool comes to a complete stop. 8 For drilling in wood, metal or plastic materials, lock button and rotate the action mode changing knob to the symbol. Use a bull point, cold chisel, scaling chisel, etc. May be swung 360° so as to be secured at any position. Coat the bit shank head beforehand with a small amount of bit grease (about 0. This chuck lubrication assures smooth action and longer service life. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. CAUTION: Do not rotate the action mode changing knob when the tool is running under load. To avoid rapid wear on the mode change mechanism, be sure that the action mode changing knob is always positively located in one of the three action mode positions. Then make sure that the bit is securely held in place by turning it slightly. The torque limiter will actuate when a certain torque level is reached. [. . . ] Pressing very hard on the tool will not increase the efficiency. When performing diamond core drilling operations, always set the change lever to the position to use "rotation only" action. CAUTION: If performing diamond core drilling operations using "rotation with hammering" action, the diamond core bit may be damaged. CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. [. . . ]