User manual MAKITA HR3530

[. . . ] Exposure to noise can cause hearing loss. Use auxiliary handles supplied with the tool. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. [. . . ] The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. CAUTION: Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Keep the tool in position and prevent it from slipping away from the hole. Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed. cAUTION: · When the bit begins to break through concrete or if the bit strikes reinforcing rods embedded in concrete, the tool may react dangerously. Maintain good balance and safe footing while holding the tool firmly with both hands to prevent dangerous reaction. Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. ⷠDo not tape, tie or otherwise secure the trigger in the "ON" position. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. After drilling the hole, use the blow-out bulb to clean the dust out of the hole. For maximum control and safer operation, always use the side grip with this tool. The side grip can be locked at four positions, horizontally and perpendicularly when the protrusion on the side grip base fits in the notch in the barrel (tool). Loosen the side grip by turning it counterclockwise, swing it to the desired position and then tighten it by turning clockwise. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. [. . . ] Send the complete tool to Makita Authorized Service Center for this lubrication service. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. These accessories or attachments are recommended for use with your Makita tool specified in this manual. [. . . ]