User manual MAKITA HT121

[. . . ] You are also asked to carefully read the safety regulations in the applicable chapter of this handbook. Important: Read the instruction handbook before using the machine. Keep other people at a safe distance whilst working. Warning: Remove the spark plug lead and read instructions before carrying out any repair or maintenance. [. . . ] €“ Every time you remove or replace the grass-catcher. – Before adjusting the grass cutting height. 20) Reduce the throttle before turning off the engine and turn the fuel off when you have finished mowing, following the instructions in the engine handbook. 21) When mowing, always keep to a safe distance from the rotating blade. This distance is the length of the handle. D) MAINTENANCE AND STORAGE 1) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. regular maintenance is essential for safety and performance. 2) Never store the equipment with fuel in the tank inside a building where vapour may reach a flame or a spark or a source of extreme heat. 3) Allow the engine to cool before storing in an enclosed space. 4) To reduce the fire hazard, keep the engine, exhaust silencer, battery compartment and fuel storage area free of grass, leaves, or excessive grease. Do not leave containers with grass cuttings in rooms. 18 GB STANDARDS OF USE For instructions regarding the engine and the battery (if supplied), read the relevant manuals. 4 When you have finishing mowing, release the brake lever (1) and disconnect the spark plug cap (2). WAIT FOR THE BLADE TO STOP before carrying out any type of work on the machine. FINISH ASSEMBLY NOTE – The machine can be supplied with some of the components already fitted. ROUTINE MAINTENANCE IMPORTANT – Regular, careful maintenance is essential for keeping the safety level and original performance of the machine unchanged in time. 1) Wear strong working gloves during any cleaning, maintenance or adjustment operation on the machine. 2) Carefully clean the machines with water after each cut; remove the grass debris and mud accumulated inside the chassis to avoid their drying and thus making the next start-up difficult. 3) The paintwork on the inside of the chassis may peel off in time due to the abrasive action of the cut grass; in this case, intervene promptly by touching up the paintwork using a rustproof paint to prevent the formation of rust that would lead to corrosion of the metal. 4) Should it be necessary to access the lower part, only tilt the machine from the side shown in the engine handbook; following the relative instructions. The warranty does not cover damage to plastic parts caused by petrol. 1 To mount the stone-guard (1), the left end of the pin (2) must be pushed through and then inserted in the hole of the left-hand (3) on the chassis. [. . . ] 1 All operations on the blade should be carried out at a specialized centre. 1 Lift the stone-guard and attach the grass-catcher (1) correctly as shown in the drawing. 2 To start the engine, follow the instructions in the engine booklet and then pull the blade brake lever (1) towards the handle and give a sharp pull on the starter cable knob (2). 3 The lawn will look better if it is always cut to the same height and in alternate directions. [. . . ]