User manual MAKITA HT155

[. . . ] They are of lightweight, handy, compact and represent professional equipment for a great variety of applications. Please read, understand and follow this booklet, which refers in detail to the various points that will demonstrate its outstanding performance. This will assist you to safety obtain the best possible results from your DOLMAR Blower. SYMBOLS It is very important to understand the following symbols when reading this instructions manual. [. . . ] This interval for every change in oil corresponds to refueling the blower approximately 10-15 times. 3) Please change the oil whenever it becomes dirty or significantly changes color. 22 L (220 ml) CAUTION • If the blower is not stored in an upright position, the oil may flow from the level gauge into the engine and give a false reading when checking the oil level. This may result in inadvertently overfilling whenever adding engine oil. € If the upper oil level limit is exceeded, this can result in the oil becoming dirty and white smoke from burning excess oil. Check Point #1: Concerning the oil cap when adding oil፧ ፧ • Wipe off dirt and grime around the opening before removing the oil cap. € Remove the oil cap and place it on a clean surface so that it does not accumulate any sand, dirt, or other foreign bodies. These may stick to the cap and adulterate the engine oil if proper care is not taken. Dirty oil containing sand, dirt, or foreign bodies may cause excessive wear on the engine due to improper lubrication and result in a breakdown. Check Point #2: If oil is spilled when adding oil፧ ፧ • Oil spillage on the outside on the blower may result in the engine oil becoming dirty or adulterated. Therefore, please wipe off any oil spillage before starting the engine. € In case of over-suction of the fuel, remove the spark plug and pull the handle several times rapidly to discharge any excess fuel. € When the throttle valve does not return to a position in contact with the idling adjusting screw even if the throttle lever is set to the low speed, correct the control cable catching state to ensure proper return of the valve. 2) When the engine is warm (1) Place the engine on a flat ground. (2) Press the primary pump several times. (3) Confirm that the choke lever is open. (4) Hold the element cover with a left hand to prevent the engine from moving, settle down to take the stable position. (5) Pull out slowly the starter handle till a certain resistance is felt. Return the starter handle backward once from this position, then pull it out (6) When the engine is difficult to start, open the throttle valve by about 1/3. Release the trigger lever to reduce the engine speed, and set the stop switch to the “O” position. 2) When the cruise control lever is except a Low-speed position. stopping 1) When the cruise control lever is a Low-speed position. [. . . ] After emptying the fuel tank, continue to run the engine and drain fuel in the carburetor. If any abnormality is found, control your machine according to the description of this manual. Never tamper or dismount any part contrary to the description. Clean Straighten fuel tube Deteriorated fuel makes starting more difficult. [. . . ]