User manual MAKITA HT163

[. . . ] They are of light weight handy, compact and represent professional equipment for a great variety of applications. Please read, understand and follow this booklet which refers in detail to the various points that will demonstrate its outstanding performance. This will assist you to safety obtain the best possible results from your DOLMAR Blower. 18 SYMBOLS It is very important to understand the following symbols when reading this instructions manual. [. . . ] Caution : The screw do not tighten strongly too much. Caution : The engine will not start unless the vacuum pipe is mounted completely. Always hold the mounting end of the vacuum pipe when attaching/ detaching the vacuum pipe. 2) Installing Elbow and Dust Bag (1) Open the fastener of the dust bag. (2) Insert the elbow into the dust bag and take it out through the bag’s entry. (4) Place clamp around the opening of the elbow. Caution : Do not perform the fastening operation in (4) above if the blower is to be used in a country or region where the CE mark is not applicable. Do not attempt to pick up large wood chips, metals, glass, stones, liquids, lighted cigarettes, fire works or the like. Always mount the protector/vacuum pipe in the right way before operation. Operation without the protector/vacuum pipe is dangerous, the impeller may catch the operator’s fingers or clothes and it can result in serious injury. Do not attempt to remove the screw (1) or disassemble the vacuum pipe. € In case of detection of any abnormality in sound, odor, vibration after start, stop the engine immediately and carry out inspection. - If the engine is operated without attending such abnormality, an accident may occur. € Confirm that the engine stops when the stop switch is set to “O” position. 1) When the engine is cold or after refuelling (1) Set this machine on a flat space. € If the primer pump is pushed excessively, an excess of gasoline returns to the fuel tank. (4) Lift the choke lever to the closed position (Figure 3). (5) Hold the main handle with left hand to prevent the engine from moving. (6) Pull out slowly the starter handle till a certain resistance is felt. Return the starter handle backward once from this position, then pull it out with force (Figure 4). € Never pull the rope to the full extension. € Once the start knob is pulled, never release your hand immediately. [. . . ] Any maintenance of adjustment work that is not included and described in this manual is only to be performed by Authorized Service Agents. STORAGE WARNING • When draining the fuel, be sure to stop the engine and confirm that the engine cools down. Drain fuel from the fuel tank and carburetor according to the following procedure: (1) Remove the fuel tank cap, and drain fuel completely. If there is any foreign matter remaining in the fuel tank, remove it completely. [. . . ]