User manual MAKITA HT2162E

[. . . ] C English / Français / Spanish HEDGE TRIMMER TAILLE-HAIES CORTASETOS HT-2145 D HT-2162 E INSTRUCTION MANUAL MANUEL D’INSTRUCTIONS MANUAL DE INSTRUCCIONES HT-2145 D HT-2162 E WARNING: To reduce the RISK of injury, user must read and understand the instruction manual before using the Hedge Trimmer. Manufacturer reserves the right to change specifications without notice. Specifications may differ from country to country. Do only hand over the Hedge Trimmer together with this manual. [. . . ] (See Starting) – Start the hedge Trimmer engine only after the entire assembly is done. Operation of the engine is only permitted after all the appropriate accessories are attached. € Before starting, make sure that the cutting device has no contact with objects such as branches, stones, etc. € Before trimming, inspect area for wires, cords, glass, or other foreign objects which could come in contact with the blade. Be aware of any and all electric lines and electric fences. Check all areas for electrical lines before cutting. Diagrammatic figure 9 STARTING THE MACHINE Move at least 3 meters away from the place of refuelling. Place the Hedge Trimmer on a clean area of ground make sure that the cutting tool does not come into contact with the ground or any other objects. Cold starting (When the engine is cold or it has been stopped for more than 5 minutes or when fuel is added to the engine. Squeeze first the lock lever A and then the throttle lever B. Keeping the throttle lever B depressed, then press the throttle lock C inward. Keeping throttle lock C depressed, release the throttle lever B. This will lock the throttle lever B in position. Hold the unit down firmly so you will not lose control while cranking the engine. If not held down properly, the engine could pull you off balance or swing the cutting blade into an obstruction or your body. Slowly pull the starter grip until resistance is felt and continue with smart pull until initial ignition are heard. Depress the choke lever (3) to the position ( ) and pull the starter rope again until the engine starts. As soon as the engine starts, immediately tap and release the throttle, thus releasing the half-throttle lock so that the engine can run in idle. Run the engine for approximately one minute at a moderate speed before applying full speed. HT-2162 E HT-2145 D HT-2162 E (1) Hot staring: (Restarting immediately after the engine has stopped) When restarting a hot engine, first try the above procedure: 1, 5, 7, 8. If the engine does not start, repeat above steps 1-11. Note: Do not pull the starter rope to its full extent and do not allow the starter grip to be retracted without control, ensure that it is retracted slowly. [. . . ] Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. PARTS COVERED Listed below are the parts covered by the Emission Component Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. 1) Fuel Metering System (i) Carburetor and internal parts (ii) Fuel filter , if applicable (iii) Throttle stopper , if applicable (iv) Choke System , if applicable Air Induction System (i) Air cleaner plate (ii) Air cleaner case (iii) Air cleaner element 2) 16 3) Ignition System (i) Spark plug (ii) Flywheel Magneto (iii) Ignition Coil Miscellaneous Items Used in Above Systems (i) Fuel hoses. [. . . ]