User manual MAKITA HT2950

[. . . ] English Thank you very much for selecting the DOLMAR Hedge Trimmer. We are pleased to be able to offer you the DOLMAR Hedge Trimmer which is the result of a long development program and many ears of knowledge and experience. The Hedge Trimmer models HT-2145 D/HT-2162 E combines the advantages of state-of-the-art technology with ergonomic design, they are light weight, handy, compact and represent professional equipment for a great variety of applications. 15 SYMBOLS It is very important to understand the following symbols when reading this instructions manual. [. . . ] To obtain optimum engine operation and to protect your health and the environment, only unleaded fuel should be used!€ For lubricating the engine use a two-stroke engine oil (quality grade:TC-3), which is added to the fuel. The engine has been designed for use with DOLMAR two-stroke engine oil and a mixture ratio of 50:1 only to protect the environment. In addition, a long service life and a reliable operation with a minimum emission of exhaust gases is guaranteed. It is absolutely essential to observe a mixture ratio of 50:1 (DOLMAR 2-stroke engine oil), otherwise the reliable function of the Hedge Trimmer cannot be guaranteed. € The correct mixture ratio: Mix 50 parts gasoline with 1 part DOLMAR 2-stroke engine oil (See table on the right) NOTE: For preparing the fuel-oil mixture, first mix the entire oil quantity with half of the fuel required. In an approved can which meets of exceeds all local code standards, then add the remaining fuel. Thoroughly shake the mixture before filling it into the Hedge Trimmer’s tank. It is not wise to add more engine oil than specified to ensure safe operation. It will only result in a higher production of combustion residues which will pollute the environment and clog the exhaust channel in the cylinder as well as the muffler. In addition, the fuel consumption will rise and the performance will decrease. If the engine does not start, repeat above steps 1-11. Note: Do not pull the starter rope to its full extent and do not allow the starter grip to be retracted without control, ensure that it is retracted slowly. Push the STOP switch (on/off switch) to “O” position, the engine rotation will become low. HT-2145 D HT-2162 E 10 OPERATION OF THE MACHINE – Be sure to carefully read and follow safety instructions. Never grasp the exposed cutting blade or cutting edges, when picking up or holding the tool. € Never touch the cutting device when starting the engine and during operation. € Operate the Hedge Trimmer in such a manner as to avoid inhalation of the exhaust gases. Never run the engine in enclosed rooms (Risk of gas poisoning). € All protective installations and guards supplied with the machine must be used during operation. € Never operate the engine with a faulty exhaust muffler or if it is missing. € Use the Hedge Trimmer only in good light and visibility. [. . . ] Then, pull the starter gently to confirm that oil film covers the engine inside and tighten the spark plug. € Clear dirt or dust from the cutter blade and outside of engine, wipe them with a oil-immersed cloth and keep the machine at a place as dry as possible. Category C=50 hours, B=125 hours, and A=300 hours. , La Mirada, California, (herein “MAKITA”) warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein “engine” ) was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. [. . . ]