User manual MAKITA HT6510

[. . . ] Always follow safety precautions in the Owner's and Safety Manual. Arm cord hook Trimming direction Tilt the blades Hedge surface to be trimmed Press Chip receiver Nut Shear blade Branch catcher Hooks Fit the hooks into groove 23. Grooves Press the hooks on both sides Unlock the hooks Screws Blade cover Under cover Gear housing cover Crank Ellipse of shear blade SPECIFICATIONS Model Blade length Strokes per minute (min-1) Overall length Net weight Safety class HT-5510 550 mm 1, 500 970 mm 4. 4 kg • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] Also wear sturdy shoes with anti-skid soles. Before starting work check to make sure that the trimmer is in good and safe working order. Check cable for damage before starting work and replace if necessary. The hedge trimmer must not be used unless fully assembled. Always work in such a way that the extension power cord is behind you. Remove plug from the mains immediately if cable is damaged or cut. Make sure you have a secure footing before starting operation. Hold the tool firmly when using the tool. Check the cutter for damage, and if damaged repair immediately. Before checking the cutter, taking care of faults, or removing material caught in the cutter, always switch off the trimmer and unplug the mains plug. Switch off the trimmer and disconnect and secure the mains plug before doing any maintenance work. When moving the hedge trimmer to another location, including during work, always unplug the mains plug. Never carry or transport the trimmer with the cutter running. Clean the hedge trimmer and especially the cutter after use, and before putting the trimmer into storage for extended periods. Lightly oil the cutter and put on the cover. The cover supplied with the unit can be hung on the wall, providing a safe and practical way to store the hedge trimmer. Store the hedge trimmer with the cover on, in a dry room. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 1) For your safety, this tool is equipped with a triple switching system. To turn on the tool, press two out of three triggers A, B and C. Release either one of the two pressed triggers to turn off. [. . . ] Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local DOLMAR Service Center. €¢ Blade cover • Hook complete • Shear blade assembly • Waist cord hook • Arm cord hook EC-DECLARATION OF CONFORMITY ENH020-1 The undersigned, as authorized by, declare that the DOLMAR machines, TYPE: HT-5510, HT-6510, HT-7510 complies with the standard safety and health requirements of the pertinent EU guidelines: EU machinery guideline 98/37/EC, Noise emission 2000/14/EG, EU EMC guideline 2004/108/EC. The requirements of the above EU guidelines were implemented chiefly on the basis of the following standards: EN60745-2-15, EN 55014, EN61000. [. . . ]