User manual MAKITA HTB7600

[. . . ] Attenzione: Read this instruction manual carefully before putting the machine into operation and strictly observe the safety regulations!The machines and tools are subject to a continuous development. We therefore reserve ourselves the right to vary at any time and without notice weights, specifications, equipment as well as the construction itself. No claims can be set up to data and drawings contained in this manual. [. . . ] This type of oil reduces the formation of ash and carbon deposits in the spark-plug, in the cylinder, in the piston and in the muffler, as well as the emission of exhaust gas. Hedge trimmer have been designed to run on both super and lead-free (green) petrol. - The chemical composition of the fuel is also important; certain components, in fact, exert aggressive action on the carburetor diaphragm, gas rings, and manifolds, etc. For this reason, only qualified brand of petrol must be used. Once you have prepared the mixture we suggest you to use it within 3-4 weeks. And flames and sources of nonelectric light, without smoking, and with the engine off. - Proceed to the filling of the tank by slowly unscrewing the cap and pouring in the mixture, being careful to avoid spilling and immediately wiping up any spills that occur from around the engine. Be careful not to spill any mixture on your clothing. - Start the engine at least three meters away from the place where the fuel tank was filled in order to avoidrisk of fire. - Never fill the fuel tank when the machines is hot. 11 ENGINE STARTING After having carried out all preparation and refuelling operations, make sure the handle push button is not on STOP. Grasp the hedgetrimmer with your left hand (Fig. 11) and slowly pull the starting cord with your right hand till the pawls hook on the handwheel. Following the hereunder specified instructions regarding the carburetor, firmly pull the starting cord till the machine starts. Never pull at stroke end in order not to damage the hooking mechanism. In accordance with the model of carburetor your machine is equipped with carry out the following operations: Carburetor with priming bulb and black start button (Fig. 2)Press once or twice the black start button B which is used to put in the right quantity of mixture for the starting. 3)Pull the starting cord for 1-2 times till the engine emits the first chugs. If the engine does not start, repeat the operation as described. Carburetor with priming bulb and without black start button (Fig. 14)in position CLOSE, pull the starting cord from 1-2 times till you hear the first chugs. Even if you do not hear them, take back the lever to position OPEN. [. . . ] It is advised to use grease suitable for high temperatures between 120° and 170°C. 21 If you notice vibrations or unusual noises, immediately stop the engine and try to find out where they come from. In case of difficult starting, for instance in pulling the starting cord, pay attention to: a) Faulty or blocked bearings. D)Break of the starting spring or clogginess of the cord. [. . . ]