User manual MAKITA HW132

[. . . ] 6 Before doing work on the appliance, REMOVE the plug. ACCIDENTAL START-UP HAZARD Before pressing the trigger, GRIP the gun firmly to counteract the recoil. INJURY HAZARD COMPLY WITH the requirements of the local water supply company. According to EN 12729 (BA), the appliance may only be connected to the mains drinking water supply if a backflow preventer valve with drain facility is installed in the supply hose. [. . . ] 2 Assembling the rotating nozzle (For models with this feature) The rotating nozzle kit delivers greater washing power. Use of the rotating nozzle may cause of reduction in pressure of 25% compared to the pressure obtained with the adjustable nozzle. However, the rotating nozzle kit delivers greater washing power due to the rotation of the water jet. Vehicle engines may be washed only if the dirty water is disposed of as per regulations in force. - Intake water temperature: see data plate on the appliance. The appliance is compliant with the EN 60335-2-79/A1 standard. Check that the electrical supply voltage and frequency (V-Hz) correspond to those specified on the appliance data plate (fig. The appliance should only be connected to a mains power supply equipped with an adequate earth connection and a differential security breaker (30 mA) to cut off the electricity supply in the instance of a short circuit. The cross-section of the extension cable should be proportionate to its length; the longer it is, the greater its cross-section should be. 3 Operator The symbol on the front cover identifies the appliance’s intended operator (professional or non-professional). Only clean or filtered water should be used for intake. The delivery of the water intake tap should be equal to that of pump capacity. Place the appliance as close to the water supply system as possible. Improper use Use by unskilled persons or those who have not read and understood the instructions in the manual is forbidden. The introduction of inflammable, explosive and toxic liquids into the appliance is prohibited. Use of the appliance in a potentially inflammable or explosive atmosphere is forbidden. The use of non-original spare parts and any other spare parts not specifically intended for the model in question is prohibited. All modifications to the appliance are prohibited. Make sure that the hose is at least Ø 13 mm and that it is reinforced. 1 English Adjusting the spray nozzle (for models with this feature) Water flow is adjusted by regulating the nozzle (E). Fill the tank with highly degradable detergent. 4 Adjusting the detergent (on models with this feature) Detergent flow is adjusted using the regulator (F). [. . . ] turn the adjustable nozzle (E) (+) (fig. 3) Wait for correct water temperature to be restored Connect appliance to the mains water supply Reduce temperature Clean nozzle (fig. 5) Check that the voltage of the mains power supply line is the same as that on the plate (fig. 2) Check characteristics of extension cable Contact your nearest Authorized Service Centre Contact your nearest Authorized Service Centre Check that the plug is firmly in the socket and that the mains voltage supply is present (*) Contact your nearest Authorized Service Centre Using the tool (M) unjam the motor from the hole at the rear of the appliance (in models with this feature) (fig. [. . . ]