User manual MAKITA JR100D

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. [. . . ] Before installing the battery cartridge into the tool, always check to see that the switch lever/trigger actuates properly and returns to the "OFF" position when released. To prevent the switch lever/trigger from accidentally pulled, the lock-off lever/button are provided. For the switch lever, pull the lock-off lever and then pull the switch lever to start the tool. The lockoff button can be pressed from either right or left. The tool speed is increased by increasing pressure on the switch lever/trigger. release the switch lever/trigger to stop. NOTICE: Do not pull the switch lever/trigger hard without pulling the lock-off lever/button. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Do not look in the light or see the source of light directly. Pull the switch lever/trigger to light up the lamp. The lamp keeps on lighting while the switch lever/trigger is being pulled. Always press the shoe firmly against the workpiece during operation. If the shoe is held away from the workpiece during operation, strong vibration and/or twisting will be produced, causing the blade to snap dangerously. ⷠAlways wear gloves to protect your hands from hot flying chips when cutting metal. ⷠBe sure to always wear suitable eye protection which conforms with current national standards. ⷠAlways use a suitable coolant (cutting oil) when cutting metal. Bring the saw blade into light contact with the workpiece. First, make a pilot groove using a slower speed. Then use a faster speed to continue cutting. You can use the switch lever or trigger according to your work. nOTE: · If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. [. . . ] Model JR100D Sound pressure level (LpA): 78 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). Model JR102D Sound pressure level (LpA): 77 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). The technical documentation is kept by our authorised representative in Europe who is: Makita International Europe Ltd. The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. [. . . ]