User manual MAKITA JR3060T

[. . . ] Holding the work by hand or against your body leaves it unstable and may lead to loss of control. Ordinary eye or sun glasses are NOT safety glasses. Inspect workpiece for any nails and remove them before operation. Check for the proper clearance beyond the workpiece before cutting so that the blade will not strike the floor, workbench, etc. [. . . ] Orbital action means that the saw blade moves up and down, and back and forth at the same time. If the tool is operated continuously at low speeds for a long period of time, the operation life of the motor will be reduced. â· The speed adjusting dial can be turned only as far as 6 and back to 1. Do not force it past 6 or 1, or the speed adjusting function may no longer work. The tools equipped with electronic function are easy to operate because of the following features. Constant speed control Electronic speed control for obtaining constant speed. Possible to get fine finish, because the rotating speed is kept constant even under load condition. Soft start feature Safety and soft start because of suppressed starting shock. Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Always clean out all chips or foreign matter adhering to the blade, blade clamp and/or slider. May cause insufficient tightening of the blade, resulting in a serious injury. To install the saw blade, always make sure that the blade clamp lever is in released position on the insulation cover before inserting the saw blade. If the blade clamp lever is in fixed position, rotate the blade clamp lever in the direction of the arrow so that it can be locked at the released position . 6) Insert the saw blade into the blade clamp as far as it will go. the blade clamp lever rotates and the saw blade is fixed. Make sure that the saw blade cannot be extracted even though you try to pull it out. If you do not insert the saw blade deep enough, the saw blade may be ejected unexpectedly during operation. [. . . ] Bring the blade into light contact with the workpiece. First, make a pilot groove using a slower speed. Then use a faster speed to continue cutting. For Model JR3060T Noise ENG102-3 The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 87 dB (A) Sound power level (LWA): 98 dB (A) Uncertainty (K): 3 dB (A) Wear ear protection. [. . . ]