User manual MAKITA LB1200F

[. . . ] Cutting capacity No load speed Cutting speed Blade size Overall dimensions Table size Net weight High Low High Low LB1200F 305 mm 165 mm 840 min-1 (50 Hz)/1, 040 min-1 (60 Hz) 420 min-1 (50 Hz)/520 min-1 (60 Hz) 13. Due to our continuing program of research and development, the specifications herein are subject to change without notice. Specifications may differ from country to country. Weight according to EPTA-Procedure 01/2003 Symbols END215-2 The following show the symbols used for the tool. [. . . ] The rip fence can be used on both sides of the blade. When the rip fence is moved from one side of the saw blade to the other the fence needs to reversed. How to load dust box The dust box is loaded from the underside of the table saw. When loading, insert plate spring (for securing) at inside edge of the machine's positioning hole, slot both shoulders of dust box onto rails, and then slide toward the outside. Once the leading edge of the securing plate spring fits into the machine's securing hole, the dust box is loaded. Fasten the guide rail with four each thumb screws and washers to the table. Before operation, make sure that the tool is turned on and off. The switch cover can be opened easily by sliding it upwards. Push the upper position (I) of the switch for turning on the light and the lower position (O) for off. Fence height can be lowered when cutting thin materials. Insert knob (A) into the other groove of the fence. If the rip fence is on the left side of the blade, slide the guide rail to the left to adjust to 0 point. The push stick serves as an extension of the hand and protects against accidental contact with the saw blade. The push stick must always be used if the distance between band saw blade and a rip fence is less than 150 mm. guide the push stick at an angle of 20º . 30º against the saw table's surface. 17) When the push stick is not used it can be stored on the push stick holder provided at the band saw frame. Contacting the band saw blade even with the band saw blade at standstill may cause a personal injury. Be sure to wear gloves when handling saw blade in situations such as removing from packaging, mounting or replacing blade. Open the upper cover and lower cover on the tool. 24) Hold the handle and pull the dust cover upwards to remove. Loosen quick release lever until the band saw blade has slackened. [. . . ] cAUTION: · Do not touch the saw blade when cutting. During saw operation, wear safety glasses, but do not wear gloves. If a dust extractor is fitted to the large opening collector, rearrange dust collector to ensure it has a large opening. During transportation the saw band guard should be fully down and close to the table. [. . . ]