User manual MAKITA LS1016FL

[. . . ] Be sure that you understand their meaning before use. To avoid injury from flying debris, keep holding the saw head down, after making cuts, until the blade has come to a complete stop. When performing slide cut, first pull carriage fully and press down handle, then push carriage toward the guide fence. Do not place hand or fingers close to the blade. [. . . ] 35) A red indicating area will appear as the lower fences are moved inward and will disappear as the lower fences are moved outward. The upper fences can be removed or moved inward and outward by loosening the levers. 36) In case of bevel-cutting, adjust the lower and upper fence positions to be as close to the blade as practical to provide maximum workpiece support, and make sure that no part of the tool, especially the blade, contacts the lower and upper fences when lowering and raising the handle fully at any position and pulling or pushing the carriage all the way at the lowest position. 37) Before cutting operations, make a dry run with the saw turned off and unplugged, then check clearance between fences and moving parts. Before cutting operations, firmly secure lower fences by tightening the clamping screws and upper fences by tightening the levers. When bevel-cutting operations are complete, don't forget to return the upper fences to the original position and return it. The use of the dust bag makes cutting operations cleaner and dust collection easier. To attach the dust bag, fit it onto the dust nozzle. When the dust bag is about half full, remove the dust bag from the tool and pull the fastener out. Empty the dust bag of its contents, tapping it lightly so as to remove particles adhering to the insides which might hamper further collection. nOTE: · If you connect a vacuum cleaner to your saw, cleaner operations can be performed. To empty the dust box, open the cover by pushing the button and dispose of the sawdust. Return the cover to the original position and lock it in place. Dust box can easily be removed by pulling it out while turning it near the dust nozzle on the tool. nOTE: · If you connect a Makita vacuum cleaner to this tool, cleaner operations can be performed. nOTICE: · Empty the dust box before collected sawdust level reaches the cylinder section. The vertical vise can be installed in two positions on either the left or right side of the base. If the screw to secure the vise arm contacts the carriage, install the screw on the opposite side of vise arm. Make sure that no part of the tool contacts the vise when lowering the handle fully and pulling or pushing the carriage all the way. if some part contacts the vise , re-position the vise. Press the workpiece flat against the guide fence and the turn base. position the workpiece at the desired cutting position and secure it firmly by tightening the vise knob. [. . . ] Misuse of an accessory or attachment may result in serious personal injury. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. ⷠSteel & Carbide-tipped saw blades Miter saw blades For smooth and precise cutting in various materials. For models LS1016L and LS1016FL only If the lens for the laser light becomes dirty, or sawdust adheres to it in such a way that the laser line is no longer easily visible, unplug the saw and remove and clean the lens for the laser light carefully with a damp, soft cloth. [. . . ]