User manual MAKITA LS1016L

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Cutting capacities Crown molding 45 ° type (with Crown molding stopper used) Base board (H) (with Horizontal vise used) No load speed (RPM) Laser Type (LS1016L only) Dimensions (L x W x H) Net weight Wavelength 650 nm, Maximum output 168 mm (6-5/8") 120 mm (4-3/4") 3, 200/min. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. ⷠNote: Specifications may differ from country to country. [. . . ] To empty the dust box, open the cover by pushing the button and throw away sawdust. Return the cover to the original position and it locks. Dust box can easily be removed by pulling out while turning it near the dust nozzle on the tool. nOTE: · If you connect a Makita vacuum cleaner to this tool, more efficient and cleaner operations can be performed. CAUTION: Empty the dust box before collected sawdust level reaches the cylinder part. The use of the dust bag makes cutting operations clean and dust collection easy. To attach the dust bag, fit it onto the dust nozzle. When the dust bag is about half full, remove the dust bag from the tool and pull the fastener out. Empty the dust bag of its contents, tapping it lightly so as to remove particles adhering to the insides which might hamper further collection. NOTE: If you connect a vacuum cleaner to your saw, more efficient and cleaner operations can be performed. WARNING: It is extremely important to always secure the workpiece properly and tightly with the vise. Also, after a cutting operation, DO NOT raise the blade until the blade has come to a complete stop. CAUTION: When cutting long workpieces, use supports that are as high as the top surface level of the turn base. Support workpiece over its entire length to avoid blade pinch and possible KICKBACK. Make a dry run with the saw turned off and check clearance. Adjust the fence to be as close to the blade as practical to provide maximum workpiece support, without interfering with arm up and down movement. When the bevel operations are complete, don't forget to relocate the fence. nOTE: · For easy tightening/loosening, the position of the lever can be changed according to your need by pulling it up. WARNING: Before operating the tool, make sure that the upper and lower fences are secured firmly. Before bevel-cutting, make sure that no part of the tool contacts the upper and lower fences when lowering the handle fully and pulling or pushing the carriage all the way. Sliding the fences to inside by loosening the clamping screw only before miter-cutting allows support of workpiece close to the saw blade. The vertical vise can be installed in two positions on either the left or right side of the base. [. . . ] If electric brake is not working well, ask your local Makita service center for repair. To remove the lens for the laser light, remove the saw blade before removing the lens according to the instructions in the section titled "Installing or removing saw blade". Loosen but do not remove the screw which secures the lens using a screwdriver. If the lens does not come out, loosen the screw further and pull out the lens again without removing the screw. [. . . ]