User manual MAKITA LXCV01

[. . . ] Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present. use only the charger supplied by the manufacturer to recharge. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. Use power tools only with specifically designated battery packs. [. . . ] To remove the battery cartridge, withdraw it from the cleaner while sliding the button on the front of the cartridge as shown in the figure. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the cleaner, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. The cleaner is equipped with the protection system, which automatically cuts off the output power for its long service life. The cleaner stops during operation when the cleaner and/or battery are placed under the following situation. This is caused by the activation of protection system and does not show the cleaner trouble. The first press on this button is for high speed and the second press for low speed and then each press on this button repeats the high/low speed cycle alternatively. CAUTION: Always be sure that the cleaner is switched off and the battery cartridge is removed before carrying out any work on the cleaner. Any work with the battery cartridge being installed on the cleaner may cause a personal injury or damage to the objects around the cleaner. When the dust bag joint and the ring inside the dust bag come off, install as follows. (1) Align the dust bag joint with the seam of the dust bag and install it so that its protrusion faces upward. Tighten the ring inside the dust bag firmly so that the pins and the ring are positioned as shown in the figure. Hold the square section of the dust bag joint and fit the pins inside the dust bag joint to the notches in the dust outlet of the cleaner and then insert and turn it clockwise all the way until it stops. At this time, make sure that the fastener part on the dust bag faces upward. Attach one end hook of the shoulder strap onto the ring in the front of the cleaner and thrust the other end of the strap through the band of the dust bag and then attach the other end hook as shown in the figure. For extending Change the front cuff of the hose according to the dust outlet size of a power tool you use. To adjust the length of the shoulder strap, pull it out to your desired length and pull the strap in the direction of arrow as shown in the figure. [. . . ] WARNING: Always be sure that the cleaner is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. CAUTION: Do not pick up materials other than dust , such as stone, wood chip and the like since this cleaner is intended for dust collection. Picking up stone, wood chip and the like may cause damage to the fan and the cleaner. CAUTION: These accessories or attachments are recommended for use with your Makita cleaner specified in this manual. [. . . ]