User manual MAKITA ML143

[. . . ] â· Note: Specifications may differ from country to country. WARNING: When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury. Some basic safety precautions are as follows: Read this instruction manual and the charger instruction manual carefully before use. do not use it in damp or wet locations. [. . . ] Switch off the light immediately when the lamp light is low. If you leave the lamp switched on, the battery capacity may decrease. Do not disassemble the charger or battery; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. If any problem develops, consult your nearest Makita Service Center or dealer. Maintenance or repairs should be carried out by Makita Authorized Service Centers to maintain product safety and reliability. If you notice that the tool is hot or is not functioning correctly, consult your nearest Makita Service Center or dealer. For Model ML142/143 only When the switch is turned "ON", the handle of the tool may become slightly hot, even if the fluorescent tube is not installed or is not lighted. This is a normal condition and does not indicate problem. Charge the battery with the Makita charger before use. To remove the battery, press the buttons on both sides of the battery and withdraw the battery from the tool. After charging, insert the battery into the tool all the way until it locks in place with a little click. 1) The following table indicates the operating time on a single charge. Always charge the Nickel Metal Hydride battery before storing it when you do not use it for more than six months. To turn on the light, depress the switch. Depress the switch once again, the light is turned off. It may cause the glass to break and result in a serious personal injury. â· Do not touch the fluorescent tube while it is in use or immediately after putting out light. â· Always be sure that the battery is removed before replacing the fluorescent tube or performing other maintenance. 3) Pull the lamp cover straight out of the main unit. [. . . ] The hook can be turned, slid and stored around the lamp cover. 6) The hook also can be removed when you do not use it. To maintain product safety and reliability, repairs and maintenance should be carried out by a Makita Authorized Service Center. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. [. . . ]