User manual MAKITA MS26C

[. . . ] ς MS-26 U MS-26 C Important: Read this instruction manual carefully before putting the Brush Cutter/String Trimmer and strictly observe the safety regulations!2 English Thank you for purchasing this DOLMAR Brush Cutter/String Trimmer. DOLMAR Brush Cutters/String Trimmers are developed as a product of our many years of knowledge, experience, and a detailed development programme. Please read this booklet thoroughly to ensure you gain the best possible performance and outstanding results that your DOLMAR Brush Cutter/String Trimmer can provide. [. . . ] € Fix the protector (1) to the clamp (3) with two M6 x 30 bolts (2). (2) (3) (1) – When using the string head, fit the protector (6) into the protector (1), and tighten them with two nuts (5) and two screws (4). (4) (1) (6) (5) 11 Mounting the cutter blade/nylon cutting head The cutter blade or nylon cutting head can be replaced easily by first turning the equipment upside down. € Insert the Allen key through the hole in the gear case and rotate the receiver washer (3) until it is locked with the Allen key. € Loosen the nut (1) (left-hand thread) with the socket wrench, and remove the nut (1) and clamp washer (2). (1) (2) (3) With the Allen key still in place – Mount the cutter blade onto the shaft so that the guide of the receiver washer (3) fits in the arbor hole in the cutter blade. Install the clamp washer (2) and secure the cutter blade with the nut (1). [Tightening torque: 13 - 23 N-m] NOTE: Always wear gloves when handling the cutter blade. nOTE: The cutter blade-fastening nut (with spring washer) is a consumable part. If there appears any wear or deformation on the spring washer, replace the nut. Allen key Loosen Tighten NOTE: The clamp washer (2), and nut (1) are not necessary for mounting the nylon cutting head. The nylon head should go on top of the receiver washer (3). (3) – Screw the nylon cutting head onto the shaft. Tighten Loosen Allen key – Make sure that the blade rotates counterclockwise. Rotation 12 Fuel/Refuelling Handling fuel Utmost care is required when handling fuel. fuel may contain substances similar to solvents. Refuel either in a well ventilated room or outdoors. Do not inhale fuel vapors, and avoid any contact of fuel or oil with your skin. Mineral oil products degrease your skin. Prolonged skin contact with these products will cause your skin to become extremely dry, which may result in various kinds of skin disease. in addition , allergic reactions may occur. Eyes can be irritated by contact with oil. [. . . ] (4) (1) (3) (2) Checking the spark plug – Only use the supplied universal wrench to remove or to install the spark plug. € The gap between the two electrodes of the spark plug should be 0. If the gap is too wide or too narrow, adjust it. If the spark plug is clogged with carton or dirty, clean it thoroughly or replace it. [. . . ]