User manual MAKITA MT230

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. For public low-voltage distribution systems of between 220 V and 250 V. Switching operations of electric apparatus cause voltage fluctuations. [. . . ] Keep proper footing and balance at all times. Keep cutting tools sharp and clean for better and safer performance. Follow instructions for lubrication and changing accessories. Inspect tool cord periodically and if damaged have it repaired by an authorized service facility. Inspect extension cords periodically and replace, if damaged. Keep handles dry, clean and free from oil and grease. When not in use, before servicing and when changing accessories such as blades, bits and cutters. Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before turning it on. Do not carry a plugged-in tool with a finger on 18. 19. 20. 21. 22. the switch. When tool is used outdoors, use only extension cords intended for outdoor use. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Be sure that others are not in the path of the sparks. Keep a proper, charged fire extinguisher closely available. If the wheel stops during the operation, makes an odd noise or begins to vibrate, switch off the tool immediately. Always switch off and wait for the wheel to come to a complete stop before removing, securing workpiece, working vise, changing work position, angle or the wheel itself. Do not touch the workpiece immediately after operation; it is extremely hot and could burn your skin. Store wheels in a dry location only. SAVE THESE INSTRUCTIONS 5 INSTALLATION 003980 Securing cut-off This tool should be bolted with two bolts to a level and stable surface using the bolt holes provided in the tool's base. This will help prevent tipping and possible personal injury. 1 2 1. Bolt holes FUNCTIONAL DESCRIPTION CAUTION: · Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 003981 Switch action · CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. 2 1 For tool with lock button 1. Switch trigger To start the tool, simply pull the switch trigger. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. [. . . ] 4. Socket wrench Guide plate Move Hex bolts 003759 · CAUTION: Remember that narrow workpieces may not be secured safely when using the two, wider interval settings. 003984 Setting for desired cutting angle To change the cutting angle, loosen the two hex bolts which secure the guide plate. Move the guide plate to the desired angle (0° - 45°) and tighten the hex bolts securely. CAUTION: Never perform right miter cuts when the guide plate is set at the 35 - 205 mm or 70 - 240 mm position. 1 2 3 1. Hex bolts · 7 ASSEMBLY · CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 003985 Removing or installing cut-off wheel (Accessory) To remove the wheel, raise the wheel guard. [. . . ]