User manual MAKITA MT240

[. . . ] Portable Cut-Off MODEL MT240 003979 DOUBLE INSULATION INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model Wheel diameter Hole diameter No load speed (min-1) Dimensions (L x W x H) Net weight Safety class MT240 355 mm 25. 4 mm 3, 800 500 mm x 280 mm x 620 mm 15. 9 kg /II · Manufacturer reserves the right to change specifications without notice. · Specifications may differ from country to country. SYMBOLS END201-2 Intended use The tool is intended for cutting in masonry and ferrous materials with appropriate abrasive cut-off wheel. [. . . ] Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off. The use of any accessory or attachment, other than those recommended in this instruction manual or the catalog, may present a risk of personal injury. Have your tool repaired by a qualified person. This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. ADDITIONAL SAFETY RULES FOR TOOL 1. Also wear hearing protection during extended periods of operation. Use only wheels recommended by the manufacturer which have a maximum ENB066-1 operating speed at least as high as "No Load RPM" marked on the tool's nameplate. Use only fiberglass-reinforced cutoff wheels. 4 3. Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately. Use only flanges specified for this tool. Be careful not to damage the spindle, flanges (especially the installing surface) or bolt, or the wheel itself might break. Keep guards in place and in working order. Make sure the wheel is not contacting the work-piece before the switch is turned on. Before using the tool on an actual workpiece, let it simply run for several minutes first. Watch for flutter or excessive vibration that might be caused by poor installation or a poorly balanced wheel. 12. Watch out for flying sparks when operating. [. . . ] CAUTION: Never perform right miter cuts when the guide plate is set at the 35 - 205 mm or 70 - 240 mm position. 1 2 3 1. Hex bolts · 7 ASSEMBLY · CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 003985 Removing or installing cut-off wheel (Accessory) To remove the wheel, raise the wheel guard. Press the shaft lock so that the wheel cannot revolve and use the socket wrench to loosen the hex bolt by turning it counterclockwise. Then remove the hex bolt, outer flange and wheel. [. . . ]