User manual MAKITA MT360

[. . . ] Router MODEL MT360 004924 005110 DOUBLE INSULATION INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model Collet chuck capacity Plunge capacity No load speed (min ) Overall height Net weight Safety class -1 MT360 12 mm or 1/2" 0 - 60 mm 22, 000 300 mm 5. 5 Kg /II · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. · Note: Specifications may differ from country to country. GENERAL SAFETY RULES ENA100-1 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit. ENB033-2 10. Be careful of the bit rotating direction and the feed direction. Always switch off and wait for the bit to come to a complete stop before removing the tool from workpiece. Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin. Always lead the power supply cord away from the tool towards the rear. Do not smear the tool base carelessly with thinner, gasoline, oil or the like. Draw attention to the need to use cutters of the correct shank diameter and which are suitable for the speed of the tool. 2. 9. 3 SAVE THESE INSTRUCTIONS 4 FUNCTIONAL DESCRIPTION · CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 004925 Adjusting the depth of cut Place the tool on a flat surface. Loosen the lock lever and lower the tool body until the bit just touches the flat surface. Press the lock lever down to lock the tool body. While pressing the fast-feed button, move the stopper pole up or down until the desired depth of cut is obtained. Minute depth adjustments can be obtained by turning the stopper pole (1. 5 mm per turn). 1 2 3 4 6 5 1. Nylon nut Stopper pole Fast-feed button Adjusting hex bolt Stopper Lock lever · CAUTION: The depth of cut should not be more than 20 mm at a pass when cutting grooves. For extra-deep grooving operations, make two or three passes with progres-sively deeper bit settings. Nylon nut For tool without the knob The upper limit of the tool body can be adjusted by turning the nylon nut. The bit will protrude dangerously. 005111 1 For tool with the knob By turning the knob, the upper limit of the tool body can be adjusted. When the tip of the bit is retracted more than required in relation to the base plate surface, turn the knob to lower the upper limit. The bit will protrude dangerously. 1. Knob 004926 Stopper block As the rotary stopper has three adjusting hex bolts, you can easily obtain three different depths of cut without readjusting the stopper pole. To adjust the hex bolts, loosen the hex nuts on them and turn the hex bolts. After obtaining the desired position, tighten the hex nuts to secure the hex bolts. 1 2 3 4 5 1. Stopper pole Chip deflector Stopper Adjusting hex bolt Hex nut 5 004927 Switch action CAUTION: Before plugging in the tool, always check to see that the tool is switched off. [. . . ] Wood Wider straight guide of desired dimensions may be made by using the convenient holes in the guide to bolt on extra pieces of wood. When using a large diameter bit, attach pieces of wood to the straight guide which have a thickness of more than 15 mm to prevent the bit from striking the straight guide. However, we do recommend its use in the inverted mode. 1 2 1. Dust cover 005114 Spacer (For tool with the knob) When operating the tool in the inverted position with the Makita Router Stand, use the spacer. [. . . ]