User manual MAKITA MT957 DC24WA

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. For Model MT951 For European countries only Noise and Vibration The typical A-weighted sound pressure level is 85 dB (A). The noise level under working may exceed 85 dB (A). [. . . ] When not in use, before servicing and when changing accessories such as blades, bits and cutters. Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before turning it on. Do not carry a plugged-in tool with a finger on the switch. When tool is used outdoors, use only extension cords intended for outdoor use. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off. The use of any accessory or attachment, other than those recommended in this instruction manual or the catalog, may present a risk of personal injury. Have your tool repaired by a qualified person. This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. 3. 10. 11. 12. 13. 3 ADDITIONAL SAFETY RULES 1. Other personal protective equipment such as dust mask, gloves, helmet and apron should be worn. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool's nameplate. When using depressed center wheels, be sure to use only fiberglassreinforced wheels. Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately. Observe the instructions of the manufacturer for correct mounting and use of wheels. Do not use separate reducing bushings or adaptors to adapt large hole abrasive wheels. [. . . ] ) Fit the wheel on over the inner flange and screw the lock nut onto the spindle. To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. To remove the wheel, follow the installation procedure in reverse. 4. Lock nut Depressed center wheel Inner flange Spindle 001649 1 2 1. [. . . ]