User manual MAKITA P-54190

[. . . ] insert the vacuum handle with the seal. Fasten the vacuum handle with a washer and hexagon hollow head plug M8x30 and insert the foot sealing into the corresponding notch. Bring the drilling stand into the correct position and switch the pump on. Check whether the four levelling screws are completely turned back and a vacuum of min. [. . . ] Operations In order to operate the tool safely, please observe the following notes: Details of the work area !Keep the work area free of everything which could obstruct operations. Lay the power cable in such a way that any damage by the drill can be avoided. Make sure to always keep the work area in view and to be able to reach all necessary operating elements and safety installations. Keep other persons away from your work area in order to avoid accidents. Space requirements for operating and maintenance Whenever possible, keep a free space for operating and maintenance of about 2 m around the drill position, so that you can work safely and have immediate access in case of a malfunction. When drilling into blocks make sure that they are well fixed and fastened. Before drilling into load bearing elements make sure that the foundations are not damaged. Follow the instructions of the specialists responsible for planning. Make sure not to damage any water or gas pipes or power lines during drilling. Make sure not to touch any metal parts of the tool when drilling in walls or floors, where power lines might be lying in water. Make sure that the drill core will not hurt anybody or cause damage to anything when falling out. When drilling through holes through ceilings, secure the area from below, as the drill core may drop downwards. If the drill core could cause damage when dropping down, set up a cordoned off area. Make sure that the drill bit is fixed correctly. Use the correct tools appropriate for the material to be worked upon. Switch the motor to ON, the drill bit must not yet touch the surface. Lower the drill bit until it touches the surface. In order to achieve an exact centering of the drill bit, minimize the forward travel of the drill bit during the first centimetre of cutting depth. If the speed is too low, the performance of the tool is impaired. If the speed is too high, the diamond segments will become blunt in a short time. Remove the bolt, which holds the support at a 90° angle, from the foot plate. [. . . ] Loosen the quick action clamping screw (D) (see page 15). Always keep the drilling stand clean, especially the drill support with the gear and the 4 sliding pieces in the holder of the machine. In order to allow the free movement of the pinion shaft it should be slightly lubricated. The sliding pieces must move along the drill support without slackness in order to achieve a good performance. [. . . ]