User manual MAKITA PB-250.4 PARTS LIST

[. . . ] Please read, understand and follow this booklet, which refers in detail to the various points that will demonstrate its outstanding performance. This will assist you to safety obtain the best possible results from your DOLMAR Blower. It is very important to understand the following symbols when reading this instructions manual. Hot surfaces - Burns to fingers or hands To ensure correct and safe operation, the user must read, understand and follow this instruction manual to assure familiarity with the handling of the blower (1). [. . . ] Recommended oil: Dolmar genuine oil or SAE10W-30 oil of API type SF grade or better (4 stroke motor oil for automobiles) Oil capacity: Approximately 0. If the blower is not stored in an upright position, the oil may flow from the level gauge into the engine and give a false reading when checking the oil level. This may result in inadvertently overfilling whenever adding engine oil. If the upper oil level limit is exceeded, this can result in the oil becoming dirty and white smoke from burning excess oil. Check Point #1: Concerning the oil cap when adding oil Wipe off dirt and grime around the opening before removing the oil cap. Remove the oil cap and place it on a clean surface so that it does not accumulate any sand, dirt, or other foreign bodies. These may stick to the cap and adulterate the engine oil if proper care is not taken. Dirty oil containing sand, dirt, or foreign bodies may cause excessive wear on the engine due to improper lubrication and result in a breakdown. Check Point #2: If oil is spilled when adding oil Oil spillage on the outside on the blower may result in the engine oil becoming dirty or adulterated. Therefore, please wipe off any oil spillage before starting the engine. When supplying the fuel, be sure to observe the following instructions to prevent ignition or fire: - - - - - Fuel supply must be made in a place free of fire. 1) When the engine is cold, or when the fuel it refueled (1) Set this machine on a flat space. (4) Continue to push the primer pump until fuel enters into the primer pump. (6) Hold the element cover with a left hand to prevent the engine from moving, settle down to take the stable position. (7) Pull out slowly the starter handle till a certain resistance is felt. Return the starter handle backward once from this position, then pull it out with force. Once the start knob is pulled, never release your hand immediately. Hold the start knob until it returns to its original point. Please do not adjust other than idling adjusting. Adjustment becomes necessary, please consult your dealership or an authorized service agent. If it is necessary to change the rotation speed, regulate the adjusting screw, with Phillips screwdriver. Turn the adjusting screw to the right, and the engine rotation will increase. [. . . ] Before making a request for repairs, check a trouble for yourself. If any abnormality is found, control your machine according to the description of this manual. Never tamper or dismount any part contrary to the description. Clean Straighten fuel tube Deteriorated fuel makes starting more difficult. [. . . ]