User manual MAKITA PC5001C

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Wheel diameter Hole diameter No load speed (RPM) Overall length Net weight · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. [. . . ] Ordinary eye or sun glasses are NOT safety glasses. Do not wrap cord around your arm or wrist. If control of tool is lost, cord may become wrapped around you and cause personal injury. If water or coolant gets into the tool or offset diamond wheel, damage to the tool or a dangerous situation may occur. Adequate ventilation of your work area is very important when using this tool. use a dust mask or appropriate respirator. Due to the dusty nature of this tool, be sure to clean it often to remove dust accumulations. Carefully blow the dust out of the motor, switch and dust cover areas frequently. Always install the dust cover before operation. always use Makita offset diamond wheels only. Never use ordinary diamond wheels which may be available on the market. Never use depressed center wheels, cut-off wheels, or any other type of accessory on this tool. Failure to do so may result in serious injury or death to operator or anyone nearby. Check the offset diamond wheel carefully for cracks or damage before operation. replace cracked or damaged wheel immediately. Before using the tool on an actual workpiece, let it run for a while, keeping it away from your body. Watch for vibration or wobbling that could indicate poor installation, a poorly balanced wheel, or a damaged wheel. Hold the tool firmly with both hands during operation. Do not leave the tool running unattended. Do not fasten or mount the tool to a bench, table or vise and then introduce workpieces to the tool. Do not touch the offset diamond wheel immediately after operation; it may be extremely hot and could burn your skin. Work the tool away from and toward you without bearing down on it. [. . . ] If the wheel and base surfaces are not aligned, loosen two hex socket head bolts securing the base. Turn three hex socket head bolts on the base clockwise and adjust the base so as to be level with the wheel surface. Retighten firmly the hex socket head bolts securing base and then lightly turn the hex socket head bolts counterclockwise so that the hex socket head bolts do not come loose during operation. To replace a worn diamond wheel with a new one, press in the shaft lock to hold the shaft steady, then loosen the lock nut counterclockwise with the lock nut wrench provided. [. . . ]