User manual MAKITA PC6412D

[. . . ] Transmission engaged SAFETY REQUIREMENTS - Your lawnmower should be used with due care and attention. Symbols have therefore been placed on various parts of the machine to remind you of the main precautions to be taken. Their full meanings are explained later on. You are also asked to carefully read the safety regulations in the applicable chapter of this handbook. [. . . ] € before adjusting the grass cutting height. 20) When mowing, always keep to a safe distance from the rotating blade. This distance is the length of the handle. D) MAINTENANCE AND STORAGE 1) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. regular maintenance is essential for safety and performance. 2) To reduce the fire hazard, keep the lawnmower, especially the engine, free of grass, leaves, or excessive grease. Do not leave containers with grass cuttings in rooms. 3) Check the stone-guard and grass-catcher frequently for wear and deterioration. 4) Periodically check the electric cables and replace them if they are damaged or if the insulation has been damaged. Never touch a badly insulated cable if it still connected to the power supply. Remove the cable from the socket before taking any action. The lawn will look better if it is always cut to the same height and in alternate directions. 1 Models with crossing lever switch: Widen both ends of the upper part of the handle (1) in order to fit the rod (2) and cable hook (3) in place. 2 Return the lower part of the handle, which is made up of two pre-assembled elements (1), to its working position and lock into place using the lower knobs (2). Attach the upper part (3) using the screws (4) supplied. The correct position for the cable hook (6) is as shown. By loosening the knobs (2) the handle can be set at three different heights. 3 With the plastic part (11) upside-down, fasten the frame (12) to the plastic part using the screws (13). Insert the frame (12) into the sack (14) and attach the plastic profile (15) with the help of a screwdriver, as shown in the drawing. Fit the edge of the cloth (16) right into the groove of the plastic part (11), starting 5-7 mm from the ends. 4 When you have finishing mowing, release the lever (1). FIRST disconnect the cable extension from the supply socket (2) and THEN from the side of the lawnmower’s switchgear (3). [. . . ] € turn the adjusting nut (2) so that the wire (3) is slightly loose and the lever (4) is idle. GRASS CUTTING Lift the stone-guard and attach the grass-catcher (1) correctly as shown in the drawing. Start the engine by pressing the safety push-button (2) and pulling the switchgear lever (1). 3 While cutting, ensure that the electric cable is Should you have any doubts or problems, do not hesitate to contact your nearest Service Centre or your Dealer. [. . . ]