User manual MAKITA PD520

[. . . ] PARTS COVERED Listed below are the parts covered by the Emission Components Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. Fuel Metering System Carburetor and internal parts Fuel filter, if applicable Throttle stopper, if applicable Choke System, if applicable Air Induction System Air cleaner plate, Air filter Air cleaner case, Intake manifold Ignition System Spark plugs Flywheel Magneto Ignition Coil Miscellaneous Items Used in Above Systems Fuel hoses, clamps and sealing gaskets OBTAINING WARRANTY SERVICE To obtain warranty service, take your engine to the nearest MAKITA Factory Service Center or service Center authorized by MAKITA. The dealer of service authorized by MAKITA will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. [. . . ] Sequence Mounting the cutting disc Inspect the disc for damage. Unscrew screw (9) and remove the spring washer (8). Place the cutting disc (5) on the arbour (7). Hinweis: The arbor hole of the cutting disc must be an exact fit with the arbor or shaft. If the arbor hole is larger, it must be fitted with an adapter ring (*). Place the spring washer (8) on the arbour and insert the screw (9) and tighten by hand. Turn the disc slowly until the stop hole of the V-belt pulley is visible in the cutting arm cover (10). Insert the Allen key (2) as far as it will go. Tighten the screw with the combination wrench (1) NOTE: Tighten the screw firmly (30 ± 2 Nm), as otherwise the cutting wheel may slip during cutting. 14 Tightening the V-belt / Checking V-belt tension IMPORTANT: If the Power Cut is new or the V-belt has been replaced, retighten the V-belt after the first hour of operation!Exact V‑belt tension is essential for maximum cutting performance with minimum fuel consumption. 15 18 * 23 22 25 24 Fuels Caution: The Power Cut uses mineral-oil products (gasoline and oil). Be especially careful when handling gasoline. Do not allow gasoline to come near flames, sparks or fire (explosion hazard). fuel mixture Gasoline 100:1 50:1 The Power Cut is powered by a high‑performance two‑stroke engine. It runs on a mixture of gasoline and two-stroke engine oil. The engine is designed for unleaded regular gasoline with a min. In case no such fuel is available, you can use fuel with a higher octane value. In order to obtain an optimum engine output and to protect your health and the environment use unleaded fuel only. Gasoline which contens alcohol should not used in MAKITA products. To lubricate the engine, use a two-stroke engine oil (quality grade JASO FC or ISO EGD), which is added to the fuel. The engine is designed for the use of MAKITA HP 100 high-performance two-stroke engine oil at a mixture ratio of only 100:1 to protect the environment. [. . . ] We will furthermore not accept any liability damages arising from the use of non-MAKITA spare parts. 30 MAKITA guarantees the highest quality and will therefore reimburse all costs for repair by replacement of damaged parts resulting from material or production faults occurring within the guarantee period after purchase. Please note that in some countries particular guarantee conditions may exist. If you have any questions, please contact your salesman, who is responsible for the guarantee of the product. [. . . ]