User manual MAKITA PS-222 TH

[. . . ] Intended use ENE016-1 The tool is intended for collecting both wet and dry dust. Power supply ENF001-1 The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. This tool should be grounded while in use to protect the operator from electric shock. Use only three-wire extension cords which have three-prong grounding-type plugs and threepole receptacles which accept the tool's plug. [. . . ] MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. This cleaner is intended for commercial use, for example in hotels, schools, hospitals, factories, shops, offices and rental businesses. After use, disconnect the power tool from the socket of cleaner. Do not use for a long time while the float is at work. Using the cleaner with its float at work for a long time can cause overheat, resulting in the cleaner deformation. Picking up foam or soapy liquid can cause foam to come out of air exit before the float works. Continuing to using in this condition may cause an electric shock and breakage of the cleaner. The cleaner has a float mechanism that prevents water from immersing into the motor when picking up more than a certain amount of water. When the tank is full and the cleaner no longer picks up water, switch off the cleaner and empty the tank. Before plugging the cleaner, always make sure that the cleaner is switched off. Plugging the cleaner with the switch on may cause an unexpected start resulting in serious personal injury. To release the caster from the locked position, raise the stopper lever. Locking the caster is convenient when storing the cleaner, stopping the work on the way and keeping the cleaner still. When moving the cleaner, make sure that the caster is unlocked. Moving the cleaner with the caster in the locked position may cause damage to the caster. The pipe holder that is excessively lowered than the intended position cannot be installed on the cord hook with the hook away from the tank cover as shown in the figure. Make sure that the two hooks of the pipe holder are hooked on the tank cover securely. Always be sure that the cleaner is switched off and unplugged before carrying out any work on the cleaner. When picking up large wastes such as planer carvings, concrete dusts or similars other than small wastes, use the 38 mm inner diameter hose (optional accessory). Using the 28 mm inner diameter hose may cause a hose stuffing and damage. Insert the hose onto the mounting port of the tank and turn it clockwise until it locks. To pick up water or wet dust, remove prefilter and damper and then use water filter. [. . . ] (The hooks are away from the tank cover. 17) Press the A section with a great force and with the A section so pressed lower the pipe holder. 18) Fit two protrusion of the pipe holder into the grooves of the tank cover and then press down the pipe holder. Take the polyethylene bag carefully out of the tank so that the polyethylene bag cannot be caught and torn by the protrusion inside the tank when emptying it. [. . . ]