User manual MAKITA PS350

[. . . ] WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. ENC007-7 Intended use The tool is intended for screw driving in wood, metal and plastic. gEA010-1 General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. [. . . ] Be careful not to scratch the lens of lamp, or it may lower the illumination. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. installing or removing battery cartridge (Fig. 1) • Always switch off the tool before installing or removing of the battery cartridge. €¢ To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge. €¢ To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. installing or removing battery cartridge (Fig. Install it fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when installing the battery cartridge. €¢ If you use a spare battery to continue the operation, rest the tool at least 15 min. The fastening torque is affected by a wide variety of factors including the following. After fastening, always check the torque with a torque wrench. When the battery cartridge is discharged almost completely, voltage will drop and the fastening torque will be reduced. Driver bit or socket bit Failure to use the correct size driver bit or socket bit will cause a reduction in the fastening torque. Bolt • Even though the torque coefficient and the class of bolt are the same, the proper fastening torque will differ according to the diameter of bolt. €¢ Even though the diameters of bolts are the same, the proper fastening torque will differ according to the torque coefficient, the class of bolt and the bolt length. The manner of holding the tool or the material of driving position to be fastened will affect the torque. Operating the tool at low speed will cause a reduction in the fastening torque. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or socket bit Use only bits that has inserting portion shown in the figure. [. . . ] MAINTENANCE CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. €¢ Never use gasoline, benzine, thinner, alcohol or the like. discoloration , deformation or cracks may result. 7 Replace when they wear down to the limit mark. [. . . ]