User manual MAKITA PS43

[. . . ] Fastener may be forcefully discharged while attempting to free a jammed condition. Do not use this nailer for fastening electrical cables. Always wear safety goggles or safety glasses with side shield, and a full face shield when needed. Keep hands and feet away from the ejection port area. [. . . ] iMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE Installing or removing battery cartridge (Fig. Install it fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. €¢ Do not use force when installing the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. ) Keeping pin nails in this position, insert these nails all the way into the driver guide. Return the magazine to the original position and lock it with the locking lever. cAUTION: • Do not use deformed connected pin nails. Using pin nails other than those specified may cause pin nail jamming and breakage of the pin nailer. Lighting up the lamps CAUTION: • Do not look in the light or see the source of light directly. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. €¢ Even if the lamp lights up when the battery power residual gets small, pin nailer may not fire pin nails. In this case, charge the battery cartridge. Unloading pin nailer CAUTION: • When removing pin nails, make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed from the pin nailer. Misfiring may cause personal injuries and property damage. [. . . ] 12) When not in use, store the hex wrench as shown in the figure to keep it from being lost. 6 OPERATION Driving pin nails WARNING: • Before pulling the trigger, always make sure that the opening that pin-nails are fired contacts material to be fastened. 13) Place flat the opening of the tool that pin-nails are fired on the material to be fastened and hold the tool firmly against the material. Then pull the lever and then pull the trigger fully to drive the pin nail. [. . . ]