User manual MAKITA PS460

[. . . ] It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. [. . . ] To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. NOTE: • Even with the switch on and motor running, the bit will not rotate until you fit the point of the bit in the screw head and apply forward pressure to engage the clutch. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 4) CAUTION: • Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out 10 - 15 seconds after releasing the trigger. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. installing or removing battery cartridge (Fig. Drive a trial screw into your material or a piece of duplicate material. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. € Phillips Insert bits • Magnetic bit holder • Various type of Makita genuine batteries and chargers • Plastic carrying case NOTE: • Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. Noise ENG905-1 The typical A-weighted noise level determined according to EN60745: Model BFS441 Sound pressure level (LpA): 70 dB (A) or less Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). Model PS460 Sound pressure level (LpA): 71 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). Vibration ENG900-1 The vibration total value (tri-axial vector sum) determined according to EN60745: Work mode: screwdriving without impact Vibration emission (ah): 2. 8) To remove the bit, pull the locator. Then grasp the bit with a pair of pliers and pull the bit out of the magnetic bit holder. [. . . ] € Make sure that the bit is inserted straight in the screw head, or the screw and/or bit may be damaged. € The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. € The declared vibration emission value may also be used in a preliminary assessment of exposure. WARNING: • The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used. [. . . ]