User manual MAKITA PS4605H

[. . . ] Use auxiliary handle(s), if supplied with the tool. loss of control can cause personal injury. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring. Cutting accessory contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. [. . . ] Then pull the switch trigger again to restart. If the tool does not start, the battery is overheated. In this situation, let the battery cool before pulling the switch trigger again. €¢ Low battery voltage: The remaining battery capacity is too low and the tool will not operate. In this situation, remove and recharge the battery. NOTE: • Those temperature-sensitive protection and low-voltage protection is applied only when the tool is used with a battery cartridge with a star mark. 3) CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. 4) CAUTION: • Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. this tool employs an action mode changing ring. Select one of the three modes suitable for your work needs by using this ring. If you operate the tool with the ring positioned halfway between the mode marks, the tool may be damaged. The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. installing the bit holder (Optional accessory) (Fig. 10) Fit the bit holder into the protrusion at the tool foot on either right or left side and secure it with a screw. When not using the driver bit, keep it in the bit holders. OPERATION CAUTION: • Always insert the battery cartridge all the way until it locks in place. [. . . ] 12) After drilling the hole, use the blow-out bulb to clean the dust out of the hole. 13) First, turn the action mode changing ring so that the arrow on the tool body points to the marking. Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. [. . . ]