User manual MAKITA PS460D

[. . . ] gEA010-1 General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. GEB088-1 Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring. [. . . ] let a hot battery cartridge cool down before charging it. In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded. Then pull the switch trigger again to restart. If the tool does not start, the battery is overheated. In this situation, let the battery cool before pulling the switch trigger again. € Low battery voltage: The remaining battery capacity is too low and the tool will not operate. In this situation, remove and recharge the battery. NOTE: • Those temperature-sensitive protection and low-voltage protection is applied only when the tool is used with a battery cartridge with a star mark. 3) CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. € Do not use the speed change lever while the tool is running. Be sure that the speed change lever is set to the correct position before operation. 12) First, turn the action mode changing ring so that the arrow on the tool body points to the marking. Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the switch trigger as soon as the clutch cuts in. CAUTION: • Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. NOTE: • When driving wood screw, predrill a pilot hole 2/3 the diameter of the screw. It makes driving easier and prevents splitting of the workpiece. 7) The fastening torque can be adjusted in 17 steps by turning the adjusting ring so that its graduations are aligned with the pointer on the tool body. The fastening torque is minimum when the number 1 is aligned with the pointer, and maximum when the m marking is aligned with the pointer. [. . . ] Turn the sleeve clockwise to tighten the chuck. To remove the bit, turn the sleeve counterclockwise. 9) The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. [. . . ]