User manual MAKITA PS5000

[. . . ] Read this instruction manual and the charger instruction manual carefully before use. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Only use attachments/accessories specified by the manufacturer. Unplug this apparatus during lighting storms or when unused for long periods of time. [. . . ] If not, it may accidentally 9 3-2. installing or removing Cluster battery cartridge (Fig. 5 - 9) • Pull the supporting bar to allow the battery to insert to the terminal. €¢ To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. • Release the supporting bar. €¢ To remove the battery cartridge, pull the supporting bar and take the battery out of the terminal. Return the battery compartment locker to the original position. Reduced power, distortion and a “stuttering sound” or low battery sign that appears on the display are all the signs that the main battery pack needs to replace. Note: The battery pack can’t be charged via the supplied AC power adaptor. When low battery sign appears and an “E” keeps on flashing is the time to replace the back up batteries. Press button to confirm hour setting, the minute digit will flash. Keep on rotating the Tuning/Volume control knob until the required frequency shown on the display. Rotate the Tuning/Volume control knob to get required sound level. Clock can be set either when the radio is power on or off. Display will show “-: - -” when the back up batteries are installed. To turn off the radio, press the Power button. Storing stations in preset memories There are 5 memory presets for each waveband. Press the Power button to turn on the radio. Tune to required station using one of the methods previously described. Press and hold down the required preset until radio beeps. The preset number will appear in the display and the station will be stored under chosen preset button. Repeat this procedure for the remaining presets. [. . . ] Press and release radio alarm button , the radio alarm symbol will flash. During radio alarm symbol flashing, press button for more than 2 seconds followed by a beep. Display Hour will flash, rotate Tuning/Volume control knob to select the hour then press button again to confirm hour setting. Follow same procedures of setting hour to set required minute. [. . . ]