User manual MAKITA PS5000HD

[. . . ] They are of light weight handy, compact and represent professional equipment for a great variety of applications. Please read, understand and follow this booklet which refers in detail to the various points that will demonstrate its outstanding performance. This will assist you to safety obtain the best possible results from your MAKITA Blower. 18 SYMBOLS It is very important to understand the following symbols when reading this instructions manual. [. . . ] € In cold or when the engine is cooled down, never open the choke lever suddenly. (8) Continue warm-up operation for 2 to 3 minutes. (9) Rotation of the engine speed stabilizes and when from low speed making at high speed rotation, if reaches the point where it accelerates smoothly, it is completion of warming-up. Open (7) 11 NOTE • The engine may be damaged if the choke lever is moved further beyond the “CLOSE” position. (8) Continue warm-up operation for 2 to 3 minutes. € If the operator keeps pulling the starter handle several times with the choke lever left in the “CLOSE” position, the engine may be difficult to start because of over-suction of the fuel. € In case of over-suction of the fuel, remove the spark plug and pull the handle several times rapidly to discharge any excess fuel. € When the throttle valve does not return to a position in contact with the idling adjusting screw even if the throttle lever is set to the low speed, correct the control cable catching state to ensure proper return of the valve. 2) When the engine is warm (1) Place the engine on a flat ground. (2) Press the primary pump several times. (3) Confirm that the choke lever is open. € • • Empty the bag in a proper timing. NOTE If this machine is operated with the protector oriented upwards or the main handle downwards, there may appear white smoke, oil contamination or oil leakage. 13 INSPECTION AND MAINTENANCE DANGER • Before inspection and maintenance, stop the engine and allow it to cool. remove also the spark plug and plug cap. - If inspection or maintenance is attempted immediately after engine stop or with the plug cap left attached, the operator may suffer burn or an accident due to careless startup. € After inspection and maintenance, be sure to confirm that all parts are assembled. Replacement of engine oil Deteriorated engine oil will shorten the life of the sliding and rotating parts to a great extent. Be sure to check the period and quantity of replacement. DANGER • In general, the engine main unit and engine oil still remain hot just after the engine is stopped. In replacement of oil, confirm that the engine main unit and engine oil are sufficiently cooled down. Otherwise, there may remain a risk of scald. [. . . ] , (herein "Makita") warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein "engine") was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fall to conform with EPA regulations during its warranty period. PARTS COVERED Listed below are the parts covered by the Emission Component Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. [. . . ]