User manual MAKITA PS500V

[. . . ] Be sure that you understand their meaning before use. Cutting means continues to run after the motor is switched off. Cd Ni-MH Li-ion In observance of European Directive 2002/96/EC on waste electric and electronic equipment, 2006/66/EC on batteries and accumulators and waste batteries and accumulators and their implementation in accordance with national laws, electric equipment and battery pack that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. ENE015-1 Intended use The tool is intended for cutting lawn edges or sprouts. [. . . ] iMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE ENC009-1 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire. Be careful not to drop or strike battery. At this time, apply a small amount of grease to the periphery of the crank using grease that the shear blades as optional accessory are provided with or that remains inside gear housing. 16) Overlap the oval hole in the upper blade with that in the lower one. Move the shear blades so that the hole in the 13 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing blade cover CAUTION: • Be careful not to contact the shear blade when installing or removing the blade cover. Contacting the shear blade may cause personal injuries. 5 & 6) Slide the blade cover from the tool’s side until the shear blade completely hides itself and then push in it lightly towards the tool from the front. To remove the blade cover, take the above installation procedure in reverse. Installing or removing base frame CAUTION: • Before installing or removing base frame, be sure to install the blade cover. € When installing or removing base frame, take care that your fingers are not be pinched between the tool and base frame. 7) To remove the base frame, upset the tool and take it out of the groove grabbing its bottom. 8) To install the base frame, fit the protrusion of base frame near the change lever into the hole for the sheared grass height setting. [. . . ] 5 dB (A) The noise level under working may exceed 80 dB (A). 5 m/s2 ENG901-1 Installing or removing chip receiver (optional accessory) CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing chip receiver. NOTE: • When replacing the chip receiver, always wear gloves so that hands and face does not directly contact the blade. failure to do so may cause personal injury. [. . . ]