User manual MAKITA PS5105H

[. . . ] Cutting accessory contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring. Fasteners contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. Be sure no one is below when using the tool in high locations. [. . . ] Charge the battery cartridge once in every six months if you do not use it for a long period of time. 3) CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. 4) CAUTION: • Do not look in the light or see the source of light directly. 6 Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out 10 -15 seconds after releasing the trigger. NOTE: • Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Before the actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. OPERATION CAUTION: • Always insert the battery cartridge all the way until it locks in place. installing the bit holder (Optional accessory) (Fig. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Select one of the three modes suitable for your work needs by using this ring. If you operate the tool with the ring positioned halfway between the mode marks, the tool may be damaged. Hammer drilling operation CAUTION: • There is a tremendous and sudden twisting force exerted on the tool/bit at the time of hole breakthrough, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. First, turn the action mode changing ring so that the arrow on the tool body points to the marking. 7) This tool employs an action mode changing ring. Be sure to use a tungsten-carbide tipped bit. Position the bit at the desired location for the hole, then pull the switch trigger. [. . . ] €¢ Never use gasoline, benzine, thinner, alcohol or the like. 13) Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. [. . . ]