User manual MAKITA PS5105HD

[. . . ] Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring. Fasteners contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. Be sure no one is below when using the tool in high locations. Do not touch the bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. [. . . ] Use Makita refreshing adapter to refresh the battery. CAUTION: • A battery cartridge extracted from the charger that has been unplugged with the battery cartridge inserted does not indicate the battery capacity due to its protective function even if the tool is switched on after the battery insertion into the tool. checking the remaining battery capacity (Fig. NOTE: • Please contact Makita Authorized Service Center if the warning lamp of the battery cartridge does not light up when using or charging. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the battery cartridge with room temperature at 10°C – 40°C (50°F – 104°F). let a hot battery cartridge cool down before charging it. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge • Always switch off the tool before insertion or removal of the battery cartridge. This indicates the appropriate time to replace the battery cartridge when the battery power becomes low. This function works when the battery power is almost used up. A series of long beeps Replace the battery with fully charged one. Replace the battery with fully charged one. A long beep Check the LED indicator, light and beeper operation This function works to check the proper operation of the LED indicator, light and beeper when a battery cartridge has been inserted into the tool. This function works when an abnormal drop of the battery voltage occurs for some reason, and the tool stops. This function works when the temperature of the controller goes up very highly, and the tool stops. This function works to avoid the tool’s immediate start upon insertion of battery cartridge into the tool with the switch trigger being pulled. A series of very short beeps __ Anti-reset of controller A series of short beeps Replace the battery with fully charged one. Remove the battery cartridge immediately and cool the tool down. Overheat A series of short beeps Operation error of the switch trigger Flickers in red and green alternatively. [. . . ] MAINTENANCE CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. €¢ Never use gasoline, benzine, thinner, alcohol or the like. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. [. . . ]