User manual MAKITA PS52

[. . . ] Save all warnings and instructions for future reference. Blades must be rated for at least the speed marked on the tool. The guard protects the operator from broken blade fragments and unintentional contact with the blade. Use only the blades specified for this tool. [. . . ] Refer to the table below for the correspondence between the sizes marked on the stopper and the biscuit size. Fine adjustments to the grooving depth can be made by turning the adjusting screw after loosening the hex nut. This may become necessary after the blade has been resharpened a few times. Size on stopper Biscuit size Depth of groove 0 0 8 mm 10 10 10 mm 20 20 12. 3 & 4) The angle guide height can be moved up and down to adjust the position of the blade in relation to the top of the workpiece. To adjust the angle guide height, loosen the lock lever down and rotate the knob until the pointer points to the desired scale graduation marked on the angle guide. Then tighten the lock lever up to secure the angle guide. The scale on the angle guide indicates the distance from the top of the workpiece to the center of the blade thickness. The angle guide is removable from the fence according to the need of your work. To remove the angle guide, loosen the lock lever and turn the knob clockwise until it comes out of the upper end of the fence. 5 & 6) NOTE: • Remove the angle guide according to the need of your work when using the tool with the angle of the fence adjusted to other than 0°. indication lamp with multi function (Fig. 10) Indication lamps are located in two positions. When the battery cartridge is inserted on the tool with the slide switch positioned in the “O (OFF)” position, the indication lamp flickers quickly for approximately one second. If it does not flicker so, the battery cartridge or indication lamp has broken. €“ Overload protection – When the tool is overloaded, the indication lamp lights up. When the load on the tool is reduced, the lamp goes out. €“ If the tool continues to be overloaded and the indication lamp continues to light up for approximately two seconds, the tool stops. This prevents the motor and its related parts from being damaged. €“ In this case, to start the tool again, move the slide switch to the “O (OFF)” position once and then to the “I (ON)” position. indication lamp with multi function (Fig. €“ Accidental re-start preventive function – Even if the battery cartridge is inserted on the tool with the slide switch in the “I (ON)” position, the tool does not start. [. . . ] €¢ Lay the vertical workpiece on the horizontal one. €¢ Remove the angle guide from the tool. • Follow the steps 2 , 4 , 6 , 7 , 8 and 11 described above. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. [. . . ]