User manual MAKITA PS9010

[. . . ] Be sure that you understand their meaning before use. Intended use ENE073-1 The tool is intended for fastening on interior work and furniture work. €¢ Always wear safety glasses to protect your eyes from dust or nail injury. WARNING: It is an employer’s responsibility to enforce the use of safety eye protection equipment by the tool operators and by other persons in the immediate working area. [. . . ] Make sure there is no one below when working in high locations, and secure the air hose to prevent danger if there is sudden jerking or catching. On rooftops and other high locations, nail as you move forward. It is easy to lose your footing if you nail while inching backward. When nailing against perpendicular surface, nail from the top to the bottom. You can perform nailing operations with less fatigue by doing so. A nail will be bent or the tool can become jammed if you mistakenly nail on top of another nail or strike a knot in the wood. The nail may be thrown and hit someone, or the tool itself can react dangerously. Be sure that dust, sand, chips and foreign matter will not enter the tool in the place where you leave it setting. Do not point the ejection port at anyone in the vicinity. Keep hands and feet away from the ejection port area. When the air hose is connected, do not carry the tool with your finger on the trigger or hand it to someone in this condition. This nailer does not fire nails without activating both the trigger and the safety elements. Before nailing, check the nailer that the safety systems is in working order by following the procedure shown below. Make sure that nails are not loaded on the tool before operation. Set the lock lever in the released position. Pull the slide door of the magazine toward yourself. Release the finger from trigger and place the safety element against the workpiece. Bring the safety element off the workpiece, pull the trigger and then place the safety element against the workpiece. If the nailer works between 5 - 7, the safety elements are not in working order. 2) • Select a compressor that has ample pressure and air output to assure cost-efficient operation. The graph shows the relation between nailing frequency, applicable pressure and compressor air output. Pressure regulators must be used to limit air pressure to the rated pressure of the tool where air supply pressure exceeds the tool’s rated pressure. [. . . ] 23) Remove two screws with the hex wrench that are securing the front driver guide. Take the jammed nails from the nail guide groove that has appeared. When it is difficult to take out the jammed nails, further remove two screws with the hex wrench that are securing the rear driver guide. Loading nailer CAUTION: • Always lock the trigger and disconnect the hose before loading the nailer. [. . . ]