User manual MAKITA RBC3101 DC24WA

[. . . ] Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control. Ordinary eye or sun glasses are NOT safety glasses. Inspect workpiece for any nails and remove them before operation. [. . . ] Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Be careful not to drop or strike battery. This system automatically cuts off power to the motor to extend battery life. The tool will automatically stop during operation if the tool and/or battery are placed under one of the following conditions: · overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the trigger switch on the tool and stop the application that caused the tool to become overloaded. Then pull the trigger switch again to restart. ⷠLow battery voltage: The remaining battery capacity is too low and the tool will not operate. If you pull the switch trigger, the motor runs again but stops soon. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the battery cartridge once in every six months if you do not use it for a long period of time. Always clean out all chips or foreign matter adhering to the blade, blade clamp and/or slider. Failure to do so may cause insufficient tightening of the blade, resulting in a serious injury. 4) Insert the recipro saw blade into the blade clamp as far as it will go. the blade clamp sleeve rotates and the saw blade is fixed. Make sure that the saw blade cannot be extracted even though you try to pull it out. cAUTION: · If you do not insert the saw blade deep enough, the saw blade may be ejected unexpectedly during operation. You can not use the jig saw blade with RBC3101. The saw blade is removed and the blade clamp sleeve is fixed at the released position. nOTE: · If you remove the saw blade without rotating the blade clamp sleeve fully, the sleeve may not be fixed. In this case, rotate the blade clamp sleeve fully, then make the sleeve fixed at the released position. When installing a jig saw blade, loosen the bolt only threequarter to one turn from the fully tightened position. [. . . ] Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. Noise ENG905-1 The typical A-weighted noise level determined according to EN60745: When not in use, store the hex wrench. It is fixed by two projections as shown in the figure to keep it from being lost. [. . . ]