User manual MAKITA RBC350E

[. . . ] Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a “live” wire will make exposed metal parts of the tool “live” and shock the operator. Always be sure you maintain good balance and firm footing. [. . . ] Use care and common sense when disposing of sheared bolt tips. Falling tips from high locations or scattered tips can cause severe injury. Removing the outer and inner sleeves CAUTION: • Be careful not to allow foreign matter to enter the insides of the tool when removing or installing the outer and inner sleeves. The outer sleeve M24 and inner sleeve M24 are factory installed. If you need other sizes for your work, replace the sleeves as follows. Loosen the two screws while holding the outer sleeve. The outer and inner sleeves will be pushed up by the springs built into the tool. 2) Press the pin down to remove the inner sleeve from the outer sleeve. Be careful not to drop the inner sleeve when removing it. 8) When the specified torque is attained, the bolt tip will be sheared at its notched portion. The bolt tip will remain inside the inner sleeve. 9) Release the switch trigger and withdraw the tool in a straight line. 10) Pull the tip ejector (tip lever) to eject the bolt tip from the tool. Catch the sheared bolt tips to prevent them from falling dangerously below. Keep the tips off of the ground, floor, walkways, etc. When placing them, be careful not to place in reverse. € Replace nut, bolt and washer all together at one time when these rotate together, nut rotates excessively or a bolt protrude from nut surface too much or less. € Do not reuse used nut, bolt and washer. [. . . ] € Do not reuse used nut, bolt and washer. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. replacing carbon brushes Remove and check the carbon brushes regularly. [. . . ]