User manual MAKITA RBL500.0597 REMPLACEMENT PARTS

[. . . ] Make sure that the blade slides smoothly before operation. Check the blades carefully for cracks or damage before operation. replace cracked or damaged blades immediately. Make sure that the flange fits in the arbor hole when installing the blade. [. . . ] Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 6 grooving depths can be preset according to the size of biscuit to be used. Refer to the table below for the correspondence between the sizes marked on the stopper and the biscuit size. Fine adjustments to the grooving depth can be made by turning the adjusting screw after loosening the hex nut. This may become necessary after the blade has been resharpened a few times. Size on stopper Biscuit size Depth of groove 0 0 8 mm 10 10 10 mm 20 20 12. The angle guide height can be moved up and down to adjust the position of the blade in relation to the top of the workpiece. To adjust the angle guide height, loosen the lock lever down and rotate the knob until the pointer points to the desired scale graduation marked on the angle guide. Then tighten the lock lever up to secure the angle guide. The scale on the angle guide indicates the distance from the top of the workpiece to the center of the blade thickness. The angle guide is removable from the fence according to the need of your work. Remove the dust bag from the tool and pull the bag's fastener out. Empty the dust bag by tapping it lightly to remove as much of the dust as possible. nOTE: · If you connect a Makita vacuum cleaner to your plate joiner, more efficient and cleaner operations can be performed. How to make joints wARNING: · Always clamp the workpiece to the workbench before each operation. Fit the two workpieces together as they will appear in the finished joint position. Mark the center of the intended biscuit grooves on the workpiece using a pencil. nOTE: · The center of grooves should be at least 50 mm from the outer edge of the workpieces. ⷠAllow 100 mm ­ 150 mm between grooves in multiple biscuit application. For Miter Joint only Clamp one workpiece to the workbench with the mitered edge facing up. Set the depth of groove according to the size of biscuit to be used. Align the center mark on the base with the pencil line on the workpiece. [. . . ] 25) To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. [. . . ]